Got my DJI Goggles 3 finally to find them UNUSABLE with DJI O3. I know, MadsTech warned about this - but I was hoping for this issue to be fixed within a month. Still hope they can fix this since it sounds quite easy to change a few lines of code to allow the re-connection on armed drones...
my findings until 25.9.2024:
Goggles 3 Firmware 1.0.400 (most current as of 24.9.24)
O3 Airunit Firmware: 1.03.000 (most current as of 24.9.24)
(G3 Bind: longpress power button!)
(from DJI Forum thread)
To check if you do have a problem, try this:
Before powering up the Goggles 3, power up you drone and ARM it (without props please)
THEN power up the goggles while the drone is already armed
googles will power up and will NOT connect to the drone!
...only after DISARM, they will connect!
Same if you are connected, armed the drone on the bench and walk away with goggles - once bitrate is low enough to loose signal, it wont come back if you go back with goggles into range. Disarm the drone and the goggles re-connect!
Possible blackscreen Issue Causes:
Control Link: nope
on bitrate changes? sometimes
auto lowpower mode on/off? nope
CH manual or auto? nope
FCC or CE mode? nope
Power connection? VBat vs BEC 9V not likely to be related to VBAT / BEC powering
(but wrong power supply voltage can cause similar "brownout" issues of course)
🌐▬▬▬▬LINKS▬▬▬▬▬▬▬▬▬▬▬▬▬▬🌐
DJI Forum thread
Ian's (MadsTech) open Letter to DJI
please check my PATREON
DO YOU WANT TO SEE MORE???
►TOP Videos
►Mountain DIVES
►Product REVIEWS
●▬▬▬EQUIPMENT▬▬▬▬▬▬▬▬▬▬▬▬▬●
Filmed with: Oneplus12, not edited at all ;)
No comments:
Post a Comment